The P0695 trouble code indicates that the Engine Control Module (ECM) or Powertrain Control Module (PCM) has detected a low voltage condition in the control circuit for Fan 3. Fan 3 is typically associated with the engine cooling system and is controlled by the ECM or PCM to regulate engine temperature. When the voltage in the control circuit falls below the specified threshold, the ECM or PCM triggers the P0695 code.
P0695 Fan 3 Control Circuit Low
Code symptoms P0695.
1. Check Engine Light (CEL) illuminated on the dashboard.
2. Engine may run warmer than normal due to insufficient cooling fan operation.
3. Reduced cooling performance, especially at idle or during slow driving conditions.
4. Overheating issues, particularly in hot weather or while towing heavy loads.
5. Engine performance may be affected, especially under heavy loads or during extended periods of operation.
This code is common in brands such as:: Chevrolet, Renault, Ford, Toyota, Nissan, Mercedes Benz, Honda.
Causes of the code P0695.
1. Faulty cooling fan motor or relay.
2. Poor electrical connection in the cooling fan control circuit.
3. Short to ground in the cooling fan control circuit.
4. Faulty ECM or PCM.
Code Solutions P0695.
1. Use a diagnostic scanner to retrieve freeze frame data and all associated trouble codes. This information can help pinpoint the root cause of the issue.
2. Inspect the cooling fan motor and relay for any signs of damage or malfunction. Test the components using a multimeter to ensure they are functioning properly. Replace any faulty components as needed.
3. Check the wiring and connectors in the cooling fan control circuit for any signs of damage, corrosion, or loose connections. Repair or replace damaged components as needed.
4. Test the voltage in the cooling fan control circuit using a multimeter. If the voltage is lower than the specified threshold, diagnose and repair any issues with the ECM or PCM or related components.
5. If the wiring, connectors, and cooling fan motor or relay are in good condition but the code persists, it may indicate a fault in the ECM or PCM. In this case, the ECM or PCM may need to be replaced or reprogrammed by a qualified technician.
6. After any repairs are made, clear the trouble codes and perform a test drive to verify that the issue has been resolved. If the code returns, further diagnosis may be necessary to identify the underlying problem.
7. Follow manufacturer-specific diagnostic procedures outlined in the vehicle’s service manual to accurately diagnose and repair issues related to the cooling fan control circuit. If needed, seek assistance from a qualified technician or dealership.